Product Questions
Product Questions
What upgrades or enhancements are available for the Mobius SP?
You can swap between the 0.3mm and 0.5mm setups depending on your project requirements, and add additional detachable glass bottles for rapid color swapping.
Aug 14, 2026 • Mobius Airbrushes
Product Questions
Which accessories and parts are compatible with the Mobius SP?
The 0.5mm Spiral MAC nozzle is compatible across Mobius series models. It utilizes standard 1/8" BSP air fittings and official Gaahleri siphon bottles and cups.
Aug 14, 2026 • Mobius Airbrushes
Product Questions
How do I adjust the spray setting on the Mobius SP for finer lines?
Install the 0.3mm needle setup, lower air pressure to approximately 15 PSI, and use a steady, close-up trigger pull over your surface.
Aug 14, 2026 • Mobius Airbrushes
Product Questions
What can I do if the main lever of the Mobius SP feels stiff or unresponsive?
Adjust rear spring sleeve tension and inspect the angled air valve stem. Ensure no paint has seeped into the trigger housing or air valve assembly.
Aug 14, 2026 • Mobius Airbrushes
Product Questions
Why does my Mobius SP spray unevenly or with overspray?
Check the consistency of your paint. Siphon-feed airbrushes are sensitive to paint viscosity, and paint that is too thick may not be drawn or atomized smoothly, resulting in a coarse or uneven spray pattern. Adjust the thinning ratio until the paint flows consistently through the siphon system.
Aug 14, 2026 • Mobius Airbrushes
Product Questions
Are there any unique maintenance steps for the Mobius SP airbrush?
Yes. Always flush the siphon-feed tube immediately after use to prevent paint from curing inside the fluid channel. During deep disassembly, remove the air cap, nozzle cap, and nozzle first. Once the nozzle has been removed, carefully remove the needle through the front of the airbrush. This helps prevent the needle tip from hitting internal components and avoids dragging paint residue into the rear spring housing.
Aug 14, 2026 • Mobius Airbrushes
Product Questions
What should I do if Mobius SP air comes out but no paint?
Check the siphon tube for blockages. If the tube is clear, ensure the needle is actually retracting when you pull the trigger back.
Aug 14, 2026 • Mobius Airbrushes
Product Questions
Why does Mobius SP airbrush pattern look distorted?
Check the needle tip under magnification. A microscopic bend or hook on the tip will distort the airflow exiting the Spiral MAC Nozzle.
Aug 15, 2026 • Mobius Airbrushes
Product Questions
Why does Mobius SP paint stop spraying mid-session?
You may have an air pocket in the siphon tube, or "tip dry" has formed on the needle. Ensure the bottle is properly vented, fully submerged, and clean dried paint off the needle tip.
Aug 14, 2026 • Mobius Airbrushes