How to assemble and disassemble the Aventus?

Assembling The Aventus

First, screw in the air valve and the needle packing guide, then insert the trigger. Next, insert the needle chucking guide back in. This is a crucial step: You have to make sure that your needle chucking guide plate is at the correct angle. Then, insert the spring, and screw in the spring sleeve and the adjustment knob.

Next, insert the needle from the front of the airbrush all the way to the back. Place the nozzle in, then screw back the nozzle cap and the air cap.

Now, push the needle to the front of the airbrush from the back. Use the correct strength; once the needle is in position, there shouldn’t be any travel margins. Do not force it in, as you might damage the needle and the nozzle. Secure it by tightening the needle chucking nut, put back the handle, and you’re done.

Disassembling The Aventus

Start by unscrewing the airbrush handle, then loosen the needle chucking nut to release the needle. Next, pull the needle out slightly, then unscrew both the air cap and nozzle cap to retrieve the nozzle inside.

Once the nozzle is removed, push the needle back in again and remove it from the front of the airbrush. You can pull the needle from the back, however, doing so might stain the back part of your airbrush with paint, which is much harder to clean. Note: The needle is extremely sharp; handle it with care.

Once the needle is out, unscrew the spring sleeve, then proceed to take out the inside components: the spring, the needle chucking guide, the adjustment knob, and the needle chucking nut. Remove the main lever from the body, unscrew the gravity fluid cup and the air valve, and you’re done. Finally, using a specialized tool, remove the needle packing guide.