Knowledge Base
Product Questions · Aventus Airbrushes
See All
Product Questions
Why does Aventus airbrush spit, splatter, or have rough patterns?
This is typically caused by paint buildup on the needle tip or the paint being too thick. Clean the tip and check your thinning ratio.
Aug 14, 2026 • Aventus Airbrushes
Product Questions
Why does Aventus paint stop spraying mid-session?
You likely have "tip dry" or a internal clog. Perform a quick reverse-flow clean or clean the needle tip with a brush and thinner.
Aug 14, 2026 • Aventus Airbrushes
Product Questions
Why does Aventus airbrush pattern look distorted?
Check your needle tip for damage. A microscopic bend or "hook" at the tip will cause a distorted or one-sided spray pattern.
Aug 14, 2026 • Aventus Airbrushes
Product Questions
What should I do if Aventus air comes out but no paint?
First, ensure the needle chucking nut is tight. If it is, your nozzle is likely fully blocked and requires a deep clean.
Aug 14, 2026 • Aventus Airbrushes
Product Questions
What should I do if the Aventus main lever sticks?
This is caused by the needle chucking guide plate being at the wrong angle. You must disassemble the airbrush and ensure the guide is inserted correctly.
Aug 14, 2026 • Aventus Airbrushes
Product Questions
Why do I get bubbles in the Aventus paint cup?
This indicates air is leaking back into the fluid chamber. Check that your nozzle cap and air cap are securely tightened (but not overtightened).
Aug 14, 2026 • Aventus Airbrushes
Product Questions
Why is Aventus airbrush paint spraying continuously without pulling back the trigger?
The needle isn't seated fully forward. Loosen the chucking nut, gently push the needle forward until it stops in the nozzle, and retighten.
Aug 14, 2026 • Aventus Airbrushes
Product Questions
Why isn’t Aventus airbrush spraying paint?
Check for a clog in the nozzle or ensure the needle chucking nut is tight. If the nut is loose, the needle won't retract when you pull the trigger.
Aug 14, 2026 • Aventus Airbrushes
Product Questions
Why does Aventus airbrush spray unevenly or with overspray?
This is usually caused by excessive air pressure. Ensure you aren't exceeding the recommended 30 PSI for general work or 15 PSI for detail work.
Aug 14, 2026 • Aventus Airbrushes
Product Questions
Does the Swallowtail SD support dual-action control?
Yes. It uses a standard dual-action trigger ( down for air, back for paint ) optimized for precise micro-movements.
Aug 14, 2026 • Aventus Airbrushes